Sounds bad but it's not, realy. Nine out of ten times this problem is solved by a service. It is a symptom that is common to most washing machines and seems worst than actually is. occasionally it may require spare.

Do not throw out what is likely to be a very good machine before speaking to me.

The machine washes and drains the water out of the drum but it will not spin the clothes dry. The clothes are dripping when removed from the machine.

This fault is mostly common with zanussi washers. There are several reasons for this type of symptom. The age of the machine, the type of machine and how it is being used may be a factor.

This is a symptom that requires more information before the cause can be determined.

This symptom is typical of washing machines over 4 years old that does over 5 loads per week. Certain things wear on these machines and will have to be replaced. When fixed, the machine is likely to lasts a good few more years.

This symptom is typical of Indesit and Ariston and some Hoover washing machines. It is their way of saying something is wrong.More often than not it is a minor problem

Further information/inspection is required so as to determine the cause.

This is caused by a short circuit. It is a common occurrence on electrical appliances. I can determine the cause.

Not normally as bad as it seems.

Is the noise there only when the drum rotates or also when it is still? Propper observation can reveal the likely causes. See "hot tips" on this page.

It is verry common for washing machines to develope bearings fault. Some only after 18 months old, others later on but mainly between 4 and 6 years old. Bearings problems are largely because of overloading.

This is a mechanical problem that is very common among washing machines. Buying a new washing machine is no guarantee that the bearings will not wear again in the same time period.

If bearings, shaft and seals are replaced, they will be good again for a similar time and cheaper than a new machine.

If you think you have bearings problems, please ring for more information.

It is very common for a washing machine to develop a leak. Luckily the repair cost is not normally very expensive. Finding leaks requires careful and thorough inspection. That is exactly what you get from me.

Power failure, either on the machine itself or at the electrical socket. Best ensure your socket is ok and that fuses are ok. Love tracing this kind of fault.

The machine must not be used until this fault is fixed. It can cause serious water damage to your home if there is total water cut off failure. A service is normally all it takes to put this minor fault right.

There are lots of defferent error codes for the various brands of washing machines. They are a way of telling you something is not quite right. Some handbook may suggest a likely cause or say "call engineer".

Thermostats, heater elements, drain pumps, water inlet valves, programers and fan motors are the kind of things that can cause this problem.

Having this fault put right is normally the cheapest option.

Thermostats, heater elements, drain pumps, water inlet valves, programers and fan motors are the kind of things that can cause this problem.

Having this fault put right is normally the cheapest option.

Thermostats, heater elements, drain pumps, water inlet valves, programers and fan motors are the kind of things that can cause this problem.

Having this fault put right is normally the cheapest option.

Thermostats, heater elements, drain pumps, water inlet valves, programers and fan motors are the kind of things that can cause this problem.

Having this fault put right is normally the cheapest option.

There are many other washing machine fault symptoms, too many to mention here. If your fault symptom is not mentioned do not be too concerned, it is likely to be one I have come across before. If it is not, my diagnostic techniques will reveal the cause.